67
47DAC OPERATING MANUAL EM-9518-B Rev.4
3
Press Alarm/
↓
or Scale/
↑
button to go to the decimal point
position setting.
• The decimal point position is indicated.
• The SD indicates ‘D-POINT’.
NOTE
• The set display scaling value Span is indicated. When ‘100000’ is set, ‘00000’ (last 5 digits) is indicated. A negative
sign is indicated.
• Skip to Step 7 if the default value is acceptable.
4
Press Shift button to shift the display into the setting standby
mode.
• The indication starts blinking, to which you can apply changes.
5
Press Up button to select the decimal point position.
• Select 2 decimal places (10
-2
).
• Press Up button to move the decimal point.
NOTE
The right figure shows a display example. Select one among “no decimal point”, and “1 decimal place” to “4 decimal
places”.
6
Press Alarm/
↓
or Scale/
↑
button to apply the new setting.
• And the next parameter setting is indicated.
NOTE
• Press Alarm/
↓
button, and the bargraph type will be indicated (‘BAR-GRH’ on the SD).
• Press Scale/
↑
button, and the display scaling value Span will be indicated (‘DISP-B’ on the SD).
7
■
TO GO ON TO SET THE BARGRAPH TYPE,
Skip to Step 2 in “7.1 BARGRAPH TYPE”.
■
TO QUIT,
Hold down Alarm/
↓
or Scale/
↑
button for 1 second or more to return to Measuring Mode.
Blinking
Blinking
