M-E ODYON proWE10/24, Инструкция по эксплуатации

Страница: 25 / 32

Position the wall receiver to be used as a repeater so that it has radio contact with
the wall receiver to which it is to forward the signal.
As soon as the wall receiver used as a repeater receives a taught-in signal, it waits
briefly to see whether the target receiver has already sent an acknowledgement.
If this is not the case, the repeater forwards the signal and then also waits for the
feedback from the target receiver and then forwards this to the hand-held trans-
mitter.
Coding
The wall-mounted receiver is coded at the factory for transmission (button on the
inputs) with a permanently assigned and unique serial number for identification.
For security reasons, this cannot be changed and allows many combinations of
the radio system. The serial number is transmitted in encrypted form in the radio
protocol and therefore cannot be copied.
To train a hand-held transmitter on an ODYON pro receiver, press the channel
button (5) on the receiver and then press the desired button on the hand-held
transmitter. After the hand-held transmitter has been successfully tuned in, the
receiver switches according to the set operating mode. Read the section "Switch-
ing operating mode" for more detailed information.
Reset (delete transmitter)
To reset the wall receiver and delete all taught-in transmitters, press and hold the
"Channel 1" button until the red and green LEDs of channel 1 and repeater light up.
The LEDs go on one after the other. Then release the button and all 4 LEDs flash 3
times to confirm. The wall receiver is now reset and the transmitters can be
relearned.
NOTE: It is not possible to delete only one transmitter.
EN
25