M-Audio BX8 D3, Руководство пользователя

Страница: 4 / 28

4
Front Panel
1. HF Driver : The tweeter outputs the high frequencies.
2. LF Driver : The woofer outputs the low frequencies.
3. Speaker Placement LED : Helps to locate an optimal
speaker placement location for stereo imaging and
frequency reproduction. When the LED turns bright, the
speaker is in an ideal setup location.
Installation
For optimal performance of the BX8 D3, please read the following thoroughly and carefully prior to
installation.
Precautions
•
Handling: Please do not touch the speaker cone. The BX8 D3 is packaged in the box tightly, so your
attention is required when taking the monitor out of the box. To avoid possible damage to the speaker
unit, hold both sides of the monitor in order to pull it out of the box. The speaker cone should not be
touched in order to avoid damage even after it is out of the box.
•
Correct Power Operation: Since the BX8 D3 contains its own amplifier, it must be connected to a
power outlet using the detachable AC cable provided. Before connecting power, please make sure
that the Voltage-Select Switch located on the speaker's rear panel is set to the appropriate position,
as described in the rear-panel features list appearing earlier in this manual.
WARNING! Use of improper Voltage-Select Switch combinations may result in hazardous conditions
and/or damage to speaker components not covered by speaker warranty.
Note: This product does not have a standby/low-power mode.
•
Connections: You can connect either an XLR balanced cable or TRS balanced/unbalanced cable
from the input of each BX8 D3 to your corresponding preamp, computer, mixer, or game console
outputs. We recommend that you use high-quality balanced or unbalanced cables for input
connections. Also, ALWAYS turn off the power of the BX8 D3 and turn the volume of the BX8 D3
down to a minimum before making the necessary connections.
Note: When using an unbalanced cable there is a greater chance of experiencing noise issues. If you are
using an unbalanced cable and you are experiencing noise issues, try connecting a balanced TRS cable or
XLR cable.
1
2
3