M/A-Com Orion, Руководство по установке

Страница: 69 / 80

Remote Mount
1. Plan the mounting locations of the two radio units. Note that the
maximum cable length allowed between the two radios is two meters.
Referring to Figure 53 and Figure 54, run Dual Radio cable
(19B802554P10 or CA101288V10) between locations for Master and
Slave radio units. Be sure to locate the P2/P3 connector assembly at the
Master radio unit.
NOTE
CA101288V10 has a pigtail (P5) at P1, an optional extension
cable (CA101288V30) can be connected to P5 and ran to the
remote control unit as the pigtail, used for easy access for
programming, keyloading and mobile data. See Figure 55.
2. After installing Master radio unit mounting hardware, connect the Dual
Radio cable connector (P3) to the Master radio unit. Tighten the two
jackscrews on P3.
3. Next, route the remote control cable (19B802554P3, 19B802554P4 or
CA101288V4) between Control Head and Master radio locations. After
installing Control Head, connect remote control cable connector (P2) to
Control Head.
4. Connect "IGN A+" lead, if option is desired. Be sure internal switch
SW601 on master radio is set properly. Refer to page 14 of this manual
for details.
5. Connect accessory cable (19B802554P6 or 19B802554P7) connector
(P1) to Control Head.
6. Connect microphone and accessories. Refer to Accessory Installation
Manual for proper connection of accessories.
7. Now connect Remote Control Cable connector (P1) to the Dual Radio
cable connector (P2), and tighten to jackscrews on P2.
8. Connect power cable and antenna, then install Master radio unit in
mounting bracket.
9. After installing Slave radio unit in its mounting hardware, connect Dual
Radio cable (P1), and tighten jackscrews. Be sure SW601 setting on
Slave radio unit is same as for Master radio unit. Connect power cable
and antenna to Slave Radio.
10. Check Dual Radio operation, using operator's manual as test guide.
69