M/A-Com Orion, Руководство по установке

Страница: 45 / 80

Siren and Light
For instructions about installing the Federal Signal Corporation Siren and
Light Kit, refer to the Federal Signal Corporation Installation Instructions
(Federal Systems part number 255287B, rev. B or higher).
Program the radio to work with the Federal Systems Siren and Light Kit,
using the instructions outlined in the ProGrammer On-Line Help under “Siren
and Light Options.”
NOTE
The following issues have been reported on some Orion
Siren/Light installations using the Federal Signal Corporation
Siren and Light Kit:
•
Occasional false activation of Siren and Light functions
when the ignition is turned to the “on” position and/or
when the vehicle is started.
•
Occasional failure to enable Siren or Light functions via
control head, which can be temporarily resolved by either
power cycling the radio or turning the car ignition “off”
and then “on” again.
•
Occasional re-activation of Siren and Light function after
siren module has been turned off
To resolve the first two issues, modify the Federal Systems control cable
as follows:
1. Remove the outer shell from the DB25 side of the Federal Systems
control cable.
2. Add a jumper from pin 1 to pin 19.
This modification to the SS2000 cable harness will disable the Orion’s
capability to turn on and off the SS2000 from the front of the control head.
The SS2000 will now be turned on and off strictly by its own ignition switch
trigger line. (Red wire from 12 pin Molex
®
connector on SS2000 siren box.)
Follow the SS2000 Federal Signal installation instructions to attach the red
ignition line correctly.
45