lyyt COB LED Strip Manual
24V Seamless COB LED Strip 5m
User Manual
Introduction
Lyyt Seamless COB LED Strip provides a continuous 'no spot' linear lighting solution. The COB
(chip on board) technology consists of 528 tightly packed LED's per metre and a phosphor
layer coating which diffuses the LED's into a seamless array of light. The flexible COB strip is
supplied on a 5m reel and can be cut to desired length along the designated cutting points,
the strip is equipped with an adhesive backing for easy installation. The 24Vdc COB strip has
a high CRI of 90 making it suitable for a wide variety of applications, such as in hospitality,
retail, offices, displays, exhibitions and more. IP20 versions are for indoor use only.
Specification
Colour temperature
156.665UK: 6500K, 156.666UK: 3000K
Voltage
24Vdc
Beam angle
180°
LED Type
Sanan
Reel Length
5m
IP Rating
IP20
Power consumption per metre
12W
Current
500mA per metre
LED quantity per metre
528
LED spacing
2mm
Cut points
4.5cm
Colour rendering index
Ra>90
Cross-section
10 x 2mm
Weight
126kg
Installation of this COB Strip should be carried out by competent electrical installers, observing the
relevant electrical safety procedures. Lyyt COB Strip has a self-adhesive backing to allow it to be easily
attached to a clean, non-porous surface.
Where less than 5m of tape is needed, there are solder points as shown below, where the tape may be
cut to size. These cut points are at 4.5cm intervals. To re-connect to another length of tape after
