1. General safety instructions
Before first use read the manual carefully and follow the
instructions contained therein. The manufacturer is not liable
for damage caused by equipment used inappropriately or by
incorrect handling.
1.1. Intended use
1. The device’s purpose is to extrude any remaining
honey from wax cappings
2.
Before use the device must be thoroughly cleaned
using detergents allowed in food industry using a soft
cloth. After cleaning rinse the device and allow it to dry
thoroughly
1.2. Bezpieczeństwo użytkowania
a) Set the device on a surface that allows full stability!
b) Do not put your hands or fingers into the feeding funnel
while turning the crank
c) The device is not intended for use by persons (including
children) with limited physical, sensory or mental abilities,
or by inexperienced users, unless under supervision or
with instructions given by an accountable party. This
device is not a toy, and shouldn’t be used as one. Children
should not to play with it.
2. Instructions for use
The machine is designed to separate honey and to
mechanically compress the wax cappings. This process takes
place inside a perforated cylinder, where a rotating press-
screw module presses the honey out, which then escapes
through the perforations into the container placed underneath.
The remaining wax is moved and pressed by the screw and is
then pushed out and into a separate container. The wax is now
ready to be melted.
IMPORTANT
!!!
When filling up make an extra care should be taken
to ensure that no hard objects (stones, metal) get
into the extruder which could damage the perforated
cylinder.
2.1. General instructions – preparation for use
An additional technical check should be carried out before the
start of the pollen harvesting season, and if any defects are
found, please contact the manufacturer.
Clean and dry thoroughly before use.
3. Product description:
1. Manual drive system
2. Powder coated steel frame
3. Stainless steel feeder funnel
4. Press screw
5. Honey container
Fig.1
1 2 3 4 5
3.1. Technical specifications
•
Acid resistant stainless steel body
•
Powder coated steel frame
•
Poliamide PA6 press-screw
•
length - 900mm.
•
width - 700mm.
•
height - 1100mm.
•
weight – 34 kg.
4. Storage
Clean and dry the unit thoroughly after use.
An additional technical check should be carried out
periodically, and if any defects are found, please contact the
manufacturer.