Figure 3.
Step 4.
Connect the two halves of the chassis together using twelve 2-56 x .250 screws.
4 x
Figure 4.
Step 5.
Using four 4-40 x 3/8" hex socket head screws, attach the 0.75" hex spacers to the board as shown.
The SSC-32 should be configured for 115.2 kbaud and DB9 communication, with the VS2=VS1
jumper installed. Remove the VL=VS jumper. Consult the SSC-32 manual if needed. Attach the wiring
harness to VS1. Connect 8" of 24awg wire (not included) AND the 9v battery clip to VL; this will
provide power for the electronics. Make sure that the red wires go to (+) and the black wires go to (-).
4 x
4 x
