LYNX
Technik
AG
yellobrik
Quick
Reference
®
CDH 1813
3G SDI to HDMI Converter
Warning
Class 1 Laser Product
Power Lead Strain Relief
SDI Input
SDI (loop) Output
SDI Fiber I/O (option)
12V Power Input
SDI Present AudioSelect
Audio Level
Power and
Prog. Settings LED
Module Settings
Module Reset
(through hole)
Analog Audio Out
USB
(
for YelloGUI and
firmware updates)
Audio Status LED
Module LEDs
The module has several LEDs included to indicate status:
SDI Present LED (electrical or fiber input)
= Valid SDI signal connected
= (out) non valid SDI signal or signal missing
Audio Status LED
= Both of the audio channels are present
= Only one of the audio channels is present
= (out) no audio present
Power / Prog Setting LED
= Power OK and no internal programmed settings are present
= Power OK and some programmed settings are active*
= One or more of module switch settings have been overwritten
with the yelloGUI application. (Operation of any local switch will
clear internal settings and restore all local switch settings)
= (out) Power not present
* Some additional internal settings have been made using the yelloGUI and the
LED indicates this by turning yellow. The module can be reset to factory defaults
by using the reset switch (recessed under a hole on the side of the module).
When reset the LED will change back to Green.
USB Port / Firmware Updates / yelloGUI
The USB interface on the module is used for firmware updates and for
control of the module using the yelloGUI software application.
To update a yellobrik, power it and connect it to the PC or Mac running
the yelloGUI software with the provided USB cable. The yelloGUI
software will indicate if a new firmware is available for the connected
module and will guide you through the update process.
Firmware updates are always free of charge.
For more information and to download the yelloGUI application please
goto:
http://yellogui.lynx-technik.com
Fiber I/O Options
The module can accommodate several fiber options which are detailed
below. These are SFP sub modules and plug into the side of the
module. We can also supply CWDM versions in 18 different
wavelengths if required (contact LYNXTechnik for more details).
HDMI
Out
AES
Out
Transceiver (send and receive)
Transmitter only
Receiver only
The module has a small hole in
the case located above the
power connection. To prevent
the power lead being
accidentally pulled out, use the
supplied tie-wrap and secure
the lead as shown opposite.
(sm) =singlemode (mm)=multimode
Wavelength
TX Power
Max Distance
Option #
1310nm (sm)
-5dBm
10km (6.2miles)
OH-TX-1 LC / OH-TX-1 ST / OH-TX-1 SC
*
Wavelength
RX Sensitivity
Option #
1270-1630nm (sm)
-19dBm
OH-RX-1-Y LC / OH-RX-1-Y ST / OH-RX-1-Y SC
*
*
These fiber options have fiber connection choices
LC=LC fiber connector
ST= ST fiber connector
SC=SC fiber connector
All other fiber options are LC connections
SFP sub module
Wavelength TX Power
RX Sensitivity Max Distance
Option #
1310nm (sm)
-5dBm
-19dBm
10km (6.2miles)
OH-TR-1
850nm (mm)
-5dBm
-15dBm
300m (984 feet)
OH-TR-0-850-MM
