Lynx Side Burner Accessory, Инструкция по использованию и установке

Страница: 11 / 28

11
safety PraCtICes
and PreCautIons:
warning
read the ‘User Manual/instal-
lation instructions’ carefully
and completely before using
your grill or grill accessory to
reduce the risk of fire, burn
hazard or other injury.
ensure that burner ties and all
packing materials are removed
before lighting any new
accessory.
at eaCh new season
at the start of each new grilling
season you should remove the
cooking grates and check the
burners, venturis, orifices and
valves for obstructions.
spiders and insects often nest
in these areas of the accessory
and can disrupt air flow, causing
damage to the accessory and
personal injury.
also, check all hoses and
fittings for damage, abrasion,
wear and tear and repair, if
necessary, before turning the
gas on.
Replacement pressure regula-
tors and hose assemblies, must
be the type specified by Lynx.
the pressure regulator and
hose assembly supplied with
the unit must be used.
if the unit is lp, screw the
regulator into the tank and leak
check the hose and regulator
connections with a soap and
water solution before operating
the burner. turn all knobs to
off then slowly turn on the
gas supply valve.
do not use any grill accessory if
you smell gas.
PurgIng the gas lInes
you should purge the gas line
of air before attempting to light
the grill accessory.
1. make sure all grill controls
are in the “off” position.
2. slowly turn on the main
gas supply.
3. push in the control knob
for the burner furthest
from the fuel source. using
the burner furthest from
the fuel source will com-
pletely purge the lines. it
will take several seconds
for the burner to light.
4. hold the knob on for
about 20 seconds to allow
the air in the system to
purge and the burner to
light
5. wait at least 5 minutes
after shutting off the
control before attempting
to light the burners.
matCh lIghtIng
if a burner fails to light after
several attempts, it can
be match lit. if you’ve just
attempted to light the burner
with the igniter, allow 5 minutes
for any accumulated gas to
dissipate before match lighting.
make sure all knobs are in the
off position. Keep your face
as far away from the burner as
possible.
using the manual lighting rod,
pass a lit match over the ports
of the burner. the lynX power
Burner features a lighting rod as
shown above.
push and turn the control
knob of the burner to ‘lite”. if
the burner does not light in 4
seconds, turn the knob off and
wait 5 minutes before attempt-
ing again.
Lighting instructions for ALL Accessories
will change square to triangle