Mounting
Holes
Molex Plug
Connector
Figure 6.
Soffit
Figure 7.
2"x 4"
Framing
1/2" Thick
Drywall
Screw
Hood
Front
STEP 5. INSTALLATION OF HOOD UNIT
1. Install the hood unit to the rough-in plate by aligning
the weld studs on the rough-in plate with the slotted
holes on the back of the hood unit. (See Figure 6.)
2. Using the hex nuts provided, secure the hood assembly
to the rough-in plate.
OPTIONAL DUCT COVER
1. Install the hood as described in “Hood Rough-In Plate Mount”
Note: Be sure to allow enough room for duct cover width
on the top section of the rough-in plate.
2. Slide Duct Cover into opening.
3. Attach Duct Cover from the inside of the hood through filter
opening using the screws provided. (See figure 8.)
Note: Do not completely tighten screws until all components
have been installed. At this point, check the alignment of the
duct to the hood. First tighten the four corners to secure the
duct, then tighten the remaining screws.
Figure 8.
Mounting
Screws
Optional
Duct Cover
4. Install the remaining #10 x 1" screws into the lower
section of hood. (See Figure 6, and front area of hood
Figure 7.)
8
3. If using internal fan LOHI, plug the fan Molex plug
into mating hood Molex plug.
