1. Install three wires: black, white and green (#16 AWG) in
1/2" conduit from the service panel to the hood junction
box. Power supply must be rated for 120v, 60Hz,
15 amps (minimum).
2. Remove junction box and selected knockout. Then install the
strain relief (conduit) connector in the rough-in plate hole.
3. Remove the junction box from the rough-in plate. Connect
black wire to power supply black wire, white wire to power
supply white wire, and green wire to power supply green wire.
4. Place all wiring connectors inside junction box and re-install
on rough-in plate.
STEP 4. ELECTRICAL CONNECTION
7
Figure 5.
Power Supply
Junction
Box
Located
inside of
rough-in
plate
To Remote
Fan
(if used)
LOHI
Fan Plate
Keyhole
Molex Plug
Connector
Fan Motor
Assembly
