32
|
INSTALLATION / USE & CARE
POTENTIAL PROBLEMS
...
continued
Pull on
spring
tabs to
release
light
cover
ROTISSERIE LIGHTS BUT GOES OUT AS SOON AS
CONTROL IS RELEASED
•
Check Thermocouple
The control knob must be held in for 30 to 60 seconds
after ignition for the rotisserie burner to stay lit. (
If the burner will not stay lit when you release the control
knob, re-light it and hold the control knob in for at least 60
seconds to allow the thermocouple to heat up.
If, after holding the control knob in for at least 60 seconds,
the burner still will not stay lit when releasing the control
knob, call for service.
LIGHTS WON’T LIGHT
• Check Power
Ensure that the grill is connected to a live AC power source
and check for rotisserie motor operation.
• Reset Transformer
Disconnect power from the grill and wait 5 minutes for the
transformer to cool down and reset. Then reconnect power.
If, after resetting the transformer and replacing bulbs, you
still do not have power, call for service.
• Replace the Bulb
Replacement bulbs are halogen, 12 volt, 10W max, T3 type
with a G4 bi-pin, and are readily available at most stores.
The glass cover is held in place by two spring tension tabs.
The bulbs are easily removable without the use of tools.
Simply grasp the glass lens at the outer corners, near
the front tension clips and push the lens back. Then, swing
the lens down and pull it loose. You may have to loosen the
screw to remove the lens.
Avoid touching the glass of a new bulb. Halogen bulbs are
very sensitive to the oils found in human skin. Touching the
bulbs may shorten their life.
Pull the bulb straight out from the socket without twisting.
Hold the bulb using a paper towel or other
cloth and gently press it straight into the
socket. The glass cover should be gently
snapped back into place.
CONTACTING CUSTOMER SERVICE
If service is required, call your authorized service agency.
Have the following information readily available.
•
Model number
•
Serial number
• Sotware
Version
•
Date purchased
•
Name of dealer from whom purchased
Clearly describe the problem that you are having. If you
are unable to obtain the name of an authorized service
agency, or if you continue to have service problems,
contact Lynx at 1-888-289-5969, or write to:
Lynx Grills
62201 Hwy 82 West
Greenwood, Mississippi 38930 USA
Record the following information indicated below. You will
need it if service is ever required. The serial number and
model number can be located on the rating plate which is
located on the underside of the drip tray and on the heat
shield behind the front panel.
Record the information indicated below. You will need it if
service is ever required.
Model number ------------------------------------------------------
Serial number -------------------------------------------------------
Date of purchase ---------------------------------------------------
Date installed ---------------------------------------------------------
Dealer’s name --------------------------------------------------------
Dealer’s Address ---------------------------------------------------
-----------------------------------------------------------------------------
If service requires installation of parts, use only authorized
parts to ensure protection under the warranty.
KEEP THIS MANUAL FOR FUTURE REFERENCE.
LYNX GRILLS, LLC
Greenwood, Mississippi 38930
THIS DESIGN CERTIFIED UNDER ANSI Z21.58; CSA 1.6 OUTDOOR COOKING GAS APPLIANCE
NAT. 4” (996 Pa) LP/PROP 10” WCP (2492 Pa)
