SA122
WALL MOUNTED 500W
HALOGEN FLOODLIGHT
•
Floodlight
‚
Cover Screw
ƒ
Junction Box
„
Glass Cover
…
Mounting Bracket
SAFETY PRECAUTIONS
l
The device is designed for indoor/outdoor
usage.
l
Do not operate the unit with wet hands or while
standing on a wet or damp surface.
l
Avoid operating the Floodlight or leaving power
cord in standing water which may lead to a
fatal shock.
l
Do not remove the wire guard or tempered
glass while the Floodlight is ON.
l
Keep away from flammable objects and
handle with care.
l
If a new glass is replaced, use only tempered
glass of equal thickness.
l
If an extension cord is needed, a 3 prong
grounded plug must be featured.
l
Follow strictly the regulations when
connecting the electrical system to this
Floodlight.
l
Minimum safe distance to flammable areas
is 1 M.
IMPORTANT
Some local building codes may require installation of
this product by a qualified electrician.
Check your local codes as they apply to your situation.
If the house wiring is of aluminum,
consult with an electrician about proper wiring
methods.
Before proceeding with the installation, TURN
OFF THE POWER TO THE LIGHTING CIRCUIT
AT THE CIRCUIT BREAKER OR FUSE BOX TO
AVOID ELECTRICAL SHOCK.
CHOOSING A MOUNTING LOCATION &
WIRING REQUIREMENT
(1) Select a location for the unit either on a wall or
eaves at a height of 1.8~2M above the ground
to prevent tampering.
(2) Install a wall switch adjacent to power
source. (FIGURE 1)
FIGURE 1
(3) Switch off the power source.
(4) Remove the mounting bracket from the
floodlight. Drill the wall and screw the bracket
onto the wall using suitable plastic wall plugs
and screws.
Note: Do not at this stage re-attach the
floodlight to the bracket.
(5) Unscrew two screws at the rear of junction
box then remove junction’s box back plate.
(6) Loosen two screws on the pressure block.
(FIGURE 2)
1
