Aut-O-Loc
TM
3 Installation Instructions
General Warnings
● Read all instructions prior to installation and use.
● This unit is not a person fall protection device.
●
This unit must be replaced after catching a falling load.
● Ensure all people are clear of backstop when operating hoisting
equipment. ( Use only supplied hardware, do not substitute)
● This unit is intended for indoor use only
● Use appropriate lock
-out and tag-out procedure for backstop hoist
when installing Autoloc.
● During installation, use a tether on the Autoloc that will prevent the
Autoloc from falling.
● Ensure that people are well clear of work area, and that no
-one is un-
derneath work platform. When installing unit ensure that work platform
is stable and clear of moving equipment during hoist operation. Work
platform (i.e. man lifts) may tip when extended to great heights. Make
sure the work platform is clear of the backstop when testing the move-
ment of the backstop and Autoloc.
● Belt must move freely through the range of backstop motion. Belt
must not rub against anything as backstop moves; abrasion may cause
Belt failure.
● Keep loose clothing, long hair and jewelry clear of equipment while
installing Autoloc.
2.
Locate the Autoloc just above and as close to the pick up point (where the lift-
ing cable attaches) on the backstop mast as possible. The warning tear tab
should be just below the white roller guides at the bottom when the backstop is
in the fully raised position and facing outward so it can be seen easily if de-
ployed.
1.
The basketball backstop must be in its deployed (down) position for installation
of the Autoloc.
Unit should be oriented so
the warning tear tab
Is visible from the front of
the basket.
Rev. 6-27-18
Warning Strip
will deploy on
side opposite
the sewn loop
if unit catches
a load.
List of contents in the box:
Description
Quantity
Aut-O-Loc
TM
3
1 each
Instruction Set
1 each
Hardware packet containing:
Nut, Hex , 3/8” Flange Lock
1 each
Nut, Hex, 1/2”
Flange Lock
2 each
Nut, Hex 5/8”
Flange Lock
1 each
Bolt, 3/8” x 3”
1 each
Bolt, 1/2” x 3”
1 each
Bolt, 1/2” x 4”
1 each
Bolt, 5/8” x 4.25”
1 each
Clamp, Belt, Buckle
1 each
Clamp, Pipe (for belt buckle)
1 each
Following is a list of necessary tools:
3/4 inch six or twelve point socket
3/4 inch combination open/box end wrench
9/16 inch socket & wrench (open or adjustable)
15/16 inch socket & wrench (open or adjustable)
5-100 ft lb torque wrench
Pictured here as
installed with 3”
pipe. The univer-
sal pipe clamp will
also accept 4”
tube.
SHIPPING WEIGHT:
19 LBS
CAPACITY:
1000 LBS
MAXIMUM BELT TRAVEL:
35 FEET
