background image

I N T R O D U C T I O N

The Lyne Contour is an adjustable seatpost that allows riders to 

adjust their saddle height remotely. This is a high quality product that 

has undergone rigorous testing and complies with ISO and EN 

standards. The result is a robust design with very little head play.

Step 1. Measure the length of the cable outer housing from the 

dropper post (in its final position) to the selected position of the 

remote lever. Use sharp side cutters to cut the cable outer to length, 

make sure to cut only the outer cable and not the inner at this point. 

Leave enough cable at the handlebars to allow for a full 180° of 

movement without restriction. Route the cable housing through the 

frame until it is sticking out of the seat tube.

Step 2. Thread the inner cable into the cable end nut. Ensure that the 

cable end nut is orientated correctly and the cable end is pulled into 

the recess, see the diagram below.

Step 3. Add the end caps to the outer cable and insert the inner cable 

leaving 12-13mm gap between the cable end nut and the end cap.

I M P O R T A N T   N O T E S  

I N S T A L L A T I O N

Ensure that you have chosen the correct seatpost diameter for 

your bicycle frame. Do not use a seatpost reducer shim with this 

seatpost, this will void your warranty and could cause damage to 

your dropper post and/or your frame.

If you have chosen an internally routed seatpost then you must 

ensure that the bicycle frame has internal dropper post routing. 

Do not attempt to modify your frame to allow internal routing, 

doing so may cause frame failure which could result in injury or 

death and could void your frame warranty.

Please ensure you have the correct travel dropper post for your 

frame and seatpost extension combination, check 

lynecomponents.com for more info.

Ensure that the seatpost is inserted past the minimum insertion 

line. Recommended seatpost clamp torque is 4-6Nm. Over 

tightening will result in a malfunctioning dropper due to 

compressed internals.

P A C K A G E   C O N T E N T S

1

2

3

4

1
2
3
4

Dropper Seatpost
Cable- inner & housing (regular shifter housing and inner)
Remote Lever Assembly
Cable End Nut

Minimum Insertion 

Remove inner cable, 

only cut outer cable.

Cable end nut

Inner cable 

WWW.LYNECOMPONENTS

.COM/VIDEOS

INTERNAL DROPPER POST SERIES

OWNERS MANUAL

Cable end cap

12-13mm

Make sure you have orientated the cable end nut correctly, 

the inner cable end should be flush when installed

Отзывы: