LXE MX5X, Справочное руководство

Страница: 204 / 296

Cisco Client Configuration 187
E-EQ-MX5CERG-D MX5X Reference Guide
Checking for the Cisco PEAP Supplicant
With a Cisco wireless device installed, open the Wireless network properties as described in
Wireless Network Configuration , later in this chapter. With the Authentication tab selected check
the text in the EAP type drop down box. Refer to the following figures to determine if Cisco
PEAP is installed.
Cisco PEAP Installed PEAP Installed
Figure 5-27 Cisco PEAP Authentications
If the Cisco installation is correct, continue with the configuration. If it is not correct, follow the
procedures below.
Note: Instructions are also included in the README file located in the \SYSTEM folder.
There are two Cisco CAB files in the \SYSTEM folder of the MX5X. The default files are
CISCO.CAB and CISCOPEAP.CAB.
The default CISCO.CAB file provides for all authentications except Cisco PEAP. When the
default CISCO.CAB file is loaded, the Wireless Network Properties screen looks like the previous
figure labeled
PEAP Installed .
If Cisco PEAP is desired:
1. Rename the CISCO.CAB file to CISCOMSCHAP.CAB.
2. Rename the CISCOPEAP.CAB file to CISCO.CAB.
3. Coldboot the mobile device to install the new driver with the registry.
The renamed CISCO.CAB file provides for Cisco PEAP and PEAP/GTC authentications. When
the renamed CISCO.CAB file is loaded, the Wireless Network Properties screen looks like the
previous figure labeled
Cisco PEAP Installed .
If it becomes necessary to switch to a different authentication than Cisco PEAP or PEAP/GTC,
1. Rename the CISCO.CAB file to CISCOPEAP.CAB.
2. Rename the CISCOMSCHAP.CAB file to CISCO.CAB
3. Coldboot the mobile device to install the new driver with the registry.