LXE E-SW-BLUESCANPG-B, Руководство пользователя, Страница: 29 / 308

Introduction 17
E-SW-BLUESCANPG-B Bluetooth Ring Scanner Guide
Replace
1. Position the trigger module on the base of the Ring Scanner, making sure the empty screw
hole is visible as shown in the following figure.
2. Find the tiny black screw that you removed previously.
Figure 1-15 Replace Trigger Module
3. Using a Phillips screwdriver with a blade diameter of 1/8” (.4mm) rotate the black screw
clockwise until the trigger module is secured to the ring scanner.
4. Install the finger strap. See Removing / Replacing the Ring Finger Strap Assembly .
Removing / Replacing the Ring Finger Strap Assembly
Note: Do not pull on the finger strap or the flexible liner to remove the finger strap assembly.
This quick disconnect function is designed for occasional safety hazards and is not
intended for daily removal.
A 20 pak of Ring Scanner Finger Straps is available from LXE (8600A401RINGSTRAP). See
Accessories .
Using the Quick Disconnect Function, grasp the finger strap and pull the finger strap out and away
from the ring scanner.
Before attaching the finger strap to the trigger module, thread the finger strap, warning label side
down, first through the hinge, then under and over the pin next to the scan button.
It should slide easily.
Cleaning the Beam Aperture
Keep fingers and rough, sharp or abrasive objects away from the beam aperture. If the aperture
becomes soiled or smudged, clean only with a standard household cleaner such as Windex®
without vinegar or use Isopropyl Alcohol. Do not use paper towels or harsh-chemical-based
cleaning fluids since they may result in damage to the aperture surface. Use a clean, damp, lint-
free cloth. Do not scrub optical surfaces. If possible, clean only those areas which are soiled.
Lint/particulates can be removed with clean, filtered canned air.