LV switch IPPBX3000, Руководство пользователя

Страница: 49 / 195

LvSwitch IPPBX 3000 Manual
47
Figure5- 9 LAN/WAN Binding
VLAN binding: Select "VLAN binding" mode, and select from the drop-down box to bind the enabled
VLAN with WAN subinterface.
Port binding: Select "Port binding" mode, and select from the drop-down box to bind the two internal
network ports on the LAN side of the device withthe WAN subinterface.
When "Port binding" is selected,the "VLAN Settings", "Port
VLAN Settings" and "VLAN Isolation" under "Basic Setup>
LAN Setup".
5.1.3
DHCP Configuration
Select “Basic Setup> DHCP”. The DHCP Settings page is displayed as shown in Figure 4-10.
Figure5- 10 DHCP SERVER Configuration

When DHCP service is select as ” Disabled”, the DHCP function on the LAN port is disabled.

DHCP service is select as "DHCP SERVER", a page pop-up shown as Figure 5-10. This product acts as
a DHCP (Dynamic Host Configuration Protocol) server and assigns IP addresses to computers in the
LAN.
DHCP SERVER Configuration
：
Table 5- 2 DHCP SERVER Configuration
Item Description
Lease Time
Enter the lease time of the assigned IP address for
computer, after the lease time, the computer must re-apply
for an address (usually a computer will automatically
apply).
Unit: second, the default value is 18000 seconds.
IP Range
The DHCP server IP address pool configuration requires
that the IP address of the LAN is on the same network
segment. You can add multiple IP address pools to set the
initial IP and end IP addresses of the address pool.
IP/MAC Add MAC and IP address bindings to meet the fixed IP