1
Remote Control LHR110EE
User Manual
These instructions should be read in conjunction
with your LHK110EK Instruction Guide and should
be retained for future reference.
The LHR110EE is only compatible with the LHK110EK
Smart Home Security System.
The Remote Controller operates on a CR2032 type
Lithium cell battery which under normal conditions will
have typical life of up to 1 year.
Loading the Battery
1. Remove the rear cover by inserting a coin into
the groove and rotating anti-clockwise.
2. Insert the battery ensuring that the +v terminal
faces upwards away from the PCB.
.
3. Fit the rear cover back onto the remote and
using the coin rotate clockwise until the groove
is straight.
Emitting the ID Code
1. Set the Control Panel into ID code learning
mode by going into settings > alarm and
choose to add a remote control.
2. Press and hold the button on the
Remote Control for more than 3 seconds. This
will emit the ID code to the control panel.
3. If code learning is successful there will be a
‘tick’ icon on the Control Panel. If not then
repeat steps 1 and 2.
Note:
To remove the Remote Control from the control
panel, simply execute the
“Unpair” function on the
panel.
Operation
There are four buttons on the Remote Control, each of
which will transmit a radio signal to the 7-inch Touch
Control Panel. Their functions are listed below:
Operation and LED
Status
Remote
Controller RF
Transmission
Operating
Status of
Control Panel
Press the
button, the LED
comes on for 1
second
Full Arm
Full Arms the
Control Panel
Press the
button, the LED
comes on for 1
second
Silent Arm
Silent Arms the
Control Panel
Press the
button, the LED
comes on for 1
second
Panic Switch
Full Alarm
Condition
Press the
button, the LED
comes on for 1
second
Disarm
Disarms the
Control Panel
When any button on the Remote Control is pressed the
LED will come on for approximately 1 second and the
radio signal will be transmitted simultaneously.
Troubleshooting
Symptom
Recommendation
LED not illuminating when
any button/switch pressed
1.
Ensure correct battery
polarity
2.
Replace with new
battery
A LED indicator
E Panic Switch
B
Full Arm
F Key Chain Ring
C
Silent Arm
G Negative Polarity
D Disarm
H Positive Polarity
