Product Name:
Resin Bunnies Water Pump Outdoor Fountain with LED Light
SKU #:
WHF1054
Contact: [email protected]
Instruction Manual
Please save this manual for future reference.
Thank you for purchasing this Luxen Home product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description
Quantity
Fountain
1
Pump
1
Faucet Spout w/ tube
1
Handle
1
Bolt
1
Nut
1
Compatible Pumps for this fountain:
Pump Model No.
JR-250
JB333
YH300-70
Tools required for assembly:
No tools required for assembly.
Assembly Instructions:
1.
Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2.
Select a flat, level surface for the assembly and final location of your fountain.
3.
Insert handle and place bolt through the holes and screw in nut. Please fountain top onto fountain base.
4.
From the opening in the back of the fountain, insert the LED connector into the pump connector, and twist
to tighten. Insert the water tube into the pump, and place the electric pump inside the fountain. Draw out
the pump cord from the back of the fountain.
5.
Add clean water to the fountain. The water level should be approximately 30mm lower than the edge of the
basin.
6.
Connect the power cable to outlet. If installed properly, water flow in the fountain will begin shortly.
7.
Please do not use the electrical plug in wet weather conditions. Please note: On first use, there may be air in
the pump. It may take several minutes until all the air escapes.
8.
To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
