Product Name:
Stone and Patina Finish Arched Top Rectangular Base Outdoor Patio Fountain
Instruction Manual
Please save this manual for future reference.
Description
Accessories standards and type
Quantity
01 Fountain
1
02 Pump w/ Adaptor
PT650-LV
1
03
Arched Top
1
Tools required for assembly:
No tools required for assembly.
Assembly Instructions:
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. Place the fountain on a flat, level surface. From the opening at the back of the fountain base, insert the
water supply tube into the pump outlet. Place the pump upright in the basin and draw the pump power cord
out of the fountain back. Insert LED connector to the cord with the pump and twist tight. Set arched top in
place and tighten wing on side opening.
(①)
4. Add clean water into the basin. The water level should be approximately 1.18in (30mm
)
lower than the edge
of the basin. The pump will be submerged in the water. (
②)
5.
Connect the pump power cord to a ground fault circuit interrupter (GFCI) outlet and the pro
duct will begin
to function as intended. (
③)
6. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
7. Do not leave your fountain running for extended periods of time when no one is present to observe the
performance.
8. Check the area around your fountain on a regular basis to ensure that there is no leakage.
9. Please refresh the fountain with water each week to ensure it in good condition.
10. Do not add any harmful chemicals to the water as it may alter the paint finish.
