Tools Required
9/16" Wrench (Not Included)
#2 Square Drive Bit
(Not Included)
Hardware List
1 - (A) Roof Assembly
2 - (B) Side Assemblies
4 - (C) Brace Assemblies
4 - (D) End Caps
Hardware
8 - 3/8" x 7" Stainless Steel Bolts
8 - 3/8" Stainless Steel Nuts
16 - 3/8" Stainless Steel Washers
8 - 3/4" Panhead Screws
56 - 2" Stainless Steel Screws
A
B
C
D
1. Lay Roof Assembly on a Soft Blanket With Slats Facing Down, Attach Side Assembly to
Roof Assembly Using 2 - 7" Bolts 2 - 3/8" Nuts & 4 - 3/8" Washers per Corner. Be Sure to Align all
Predrilled Holes & match all numbers & or letters. Hand Tighten Bolts then Position Swing
Stand Upright & Tighten Bolts.
Page 1 of 2
Classic Vinyl Swing Stand Assembly Instructions
10/16/ 2017
R.M.
Inch
0
1
2
3
4
5
6
7