Luxaire K*BC090A Series, Инструкция по установке

Страница: 1 / 16

GENERAL
These completely assembled 5, 7-1/2 and 10 ton blower
units include a well insulated cabinet, a DX cooling coil with
copper tubes and aluminum fins, an expansion valve, a
distributor, throwaway filters, a centrifugal blower, a blower
motor contactor and a small holding charge of refrigerant-22.
Blower motors and adjustable drives are factory-installed on
all units.
The units are shipped in the vertical position ready for field
installation. For horizontal installation, reverse the solid
bottom panel and the return air duct flange on the front of
the unit.
INSPECTION
As soon as a unit is received, it should be inspected for
possible damage during transit. If damage is evident, the
extent of the damage should be noted on the carrier’s freight
bill. A separate request for inspection by carrier’s agent
should be made in writing.
RENEWAL PARTS
Refer to Parts Manual for complete listing of replacement
parts on this equipment for complete listing of replacement
parts. The forms referenced in this instruction may be
ordered from:
Publications Distribution Center
Unitary Products Group
P.O. Box 1592, York, PA. 17405
This instruction covers the installation and operation of
evaporator blower units. For information on the operation of
the matching condensing unit, refer to Forms 550.46-N1W,
550.46-N2W and 550.23-N1W.
Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or make the installa-
tion easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that personal injury and / or equipment
damage may result if installation procedure is not handled properly.
MODELS K*BU060A, K*BC090A, & K*BC120A
035-16673
INSTALLATION
INSTRUCTION
AIR COOLED
SPLIT-SYSTEM AIR CONDITIONERS
Supersedes: 550.23-N2W (589) 550.23-N2Z (399)