NOTE:
Deselected/inactive
Group numbers are not
illuminated .
NOTE:
Selected/active Group
number(s) (1-6) are illuminated .
5
[ 8 ]
[ 9 ]
Duplicating a Remote
Duplicating a remote copies a remote’s unique Group programming information and transfers it to
another remote so that they are essentially identical . Window coverings programmed to operate
with one remote will also respond to commands from a duplicated remote . Duplicating a remote
is not the same
as pairing multiple remotes to a PowerView® Shade Network .
Source
Target
NOTE:
Group number (1-6) buttons
will flash twice on the initial press
of Reset button, then again at six
seconds . Target remote now ready
to receive information from source
remote .
Target
Source
Target
NOTE:
The source
remote is the remote
to be duplicated . The
target remote is the
remote that receives
the source remote’s
Group programming
information .
4
2
3
1
Using a paper clip,
PRESS
and
HOLD
recessed Reset button
on back of
target remote for
6-10 seconds
. If
necessary, remove back cover .
Simultaneously. . .
PRESS
and
RELEASE
n
(Stop)
on source
remote .
RELEASE All
on target remote .
PRESS
and
HOLD All
on target
remote .
On source remote,
PRESS
and
HOLD
n
(Stop)
until indicator lights begin
to blink . Source remote is now in
Programming Mode .
SELECT
the
source remote.
SELECT
the
target remote.
NOTE:
The Group numbers (1-6) on
the target remote will flash twice . This
indicates that the source remote’s
Group programming information has
been duplicated and transferred to
the target remote . Both remotes are
now identical .
1
1
PRESS
and
RELEASE
desired
Group
number(s) (1-6)
PRESS
and
RELEASE
desired
Group
number(s) (1-6).
Selecting & De-selecting Groups
Before operating a single window covering you must first select its corresponding Group number (1-6) or the ALL
button . Multiple Group numbers can be selected for simultaneous operation in any combination . Group numbers
can be selected or deselected . Like any Group number, the ALL button can also be selected or deselected;
however, its selection will override any active Group(s) .
Selecting a Group
De-selecting a Group
RELATED TOPICS
RELATED TOPICS