Installation Settings Guide
In this guide we will describe the advanced
installation settings that you can access from
KONOz’s main menu. We recommend that
an HVAC service professional uses these settings
to fine-tune your thermostat’s performance for
your home.
You can access the installation settings by going to
the main menu and selecting the gear icon. You
will see “IS” on the screen and will be prompted to
select “yes” or “no”. Select “yes” to access the
installation settings. Rotate the knob to view
settings and press the knob to confirm.
Once in the installer settings, rotate the knob to
change a setting value. Press the knob to confirm
the new value and proceed to the next option.
There are three ways to exit the settings:
1. Continue through the remaining settings until you
pass setting 99.
2. Press and hold the knob for 3 seconds after you
confirm any changes to your settings.
3. Wait 60 seconds after you confirm any changes
to your settings.
Installation Settings Guide
System Type & Configuration
You will first see your current system type and configuration – confirm by pressing the knob
and then you will begin navigating through the available settings.
HVAC system type
F = Furnace
HP = Heat Pump
Available System
Modes
HVAC system subtype
Furnace Systems
ELEC: Electric fan. Thermostat calls fan
to run with heat
GAS: Gas fan. Thermostat does not call
fan to run with heat
BOIL: Boiler. No fan connected to
heating system
Heat Pump
o: Changeover valve = O
b: Changeover valve = B
All manuals and user guides at all-guides.com
all-guides.com
