Lux Tools 380453, Оригинальное руководство пользователя, Страница: 24 / 104

GB
24
Risks caused by vibrations
CAUTION! Risk of injury due to vibra-
tions!
Vibrations may, in particular for per-
sons with circulation problems, cause dam-
age to blood vessels and/or nerves.
If you notice any of the following symptoms,
stop working immediately and consult a doc-
tor. Numbness of body parts, loss of sense
of feeling, itching, pins and needles, pain,
changes in skin colour.
The vibration values specified in the technical data
represent the main uses of the device. The actual
existing vibrations during use may deviate from these
as a result of the following factors:
• Incorrect use of the product;
• Unsuitable tools inserted;
• Unsuitable material;
• Insufficient maintenance.
You can reduce the risks considerably by following
the tips below:
– Maintain the device in accordance with the
instructions in the operating instructions.
– Avoid working at low temperatures.
– When it is cold, make sure your body and your
hands, in particular, are kept warm.
– Take regular breaks and move your hands at the
same time to promote circulation.
Remaining risks
There will still be residual risks even when the device
is used according to the instructions and under obser-
vation of all of the safety notes in this set of operating
instructions:
•
Touching the tool in the uncovered section.
•
Reaching into the operating tool.
• Kickback from work pieces and work piece parts.
Personal protective clothing
Wear goggles and ear defenders when using
the device.
When working with tools that cause consider-
able dust, wear a dust protection mask.
Do not wear protective gloves when working
with the device.
Wear tight fitting clothes when working with
the device.
If you have long hair, cover or wear a hair net.
Your unit at a glance
Note: The actual appearance of your prod-
uct may differ from the illustrations.
►
P. 3, item 1
1. Tool holder
2. Switch for drilling / hammer drilling
3. Locking button
4. On/off switch
5. Rotational speed controller
6. Rotation direction switch
7. Additional handle
8. Holder for the depth stop
Scope of delivery
• Impact drill
• Additional handle
• Depth stop
• Operating manual
Assembly
Attaching the additional handle
– Push the additional handle (7) over the tool holder
and screw into place.
Attaching the depth stop
– Loosen the additional handle (7).
– Insert the depth stop into the holder (8).
– Set the depth stop to the required depth.
– Screw the additional handle (7) tighter.
Operation
Removing a tool
CAUTION! Risk of injury! Shortly after
being used, the tool may be very hot. Risk of
burning! Allow a hot tool to cool down. Never
clean a hot tool with flammable liquids.
►
P. 3, item 2
– Hold on to rear sleeve of tool holder (1).
– Open the front sleeve by turning clockwise.
– Remove the tool.
Inserting a tool
WARNING! Risk of injury! Make sure that
when installing the tool that it fits securely in
the clamping chuck and is not at an angle.
Note: Clean and grease the shaft of the tool
before inserting.
►
P. 3, item 2
– Place the tool as far as it will go into the tool
holder (1).
– Close the front sleeve of the tool holder by turning
anti-clockwise.
Selecting the operating mode
NOTICE! Risk of damage to the unit!
Only change operating mode when the
device is switched off.
NOTICE! Risk of damage to the unit! Do
not use setting [ ] for screwing in and
removing screws.
The protective insulation creates protection
from contact with electric parts under power
by providing additional insulation around the
necessary operational basic insulation. The
protective insulation corresponds to protec-
tion class II.