Lutz NG10, Руководство пользователя

Страница: 23 / 36

23
0698-701 Relay module - 04/2021
en
NOTICE
►
Use the supplied Allen key SW3 for the screws.
► Only tighten the screws hand-tight.
1. Pull out the plug of the relay module/power supply unit.
2. Remove the caps and release the screws of the operating unit/protection cap.
3. Carefully lift the operating unit/protection cap. Pay attention to cable length!
4. Release the connecting cable.
5. Remove the screws at the relay module/power supply unit.
6. Carefully lift the relay module/power supply unit. Pay attention to cable length!
7. Release the connecting cable.
8. Check the fine wire fuses and replace if necessary.
9. Plug the connecting cable back into the intermediate plate.
10. Use the screws to secure the relay module/power supply unit to the intermediate plate.
11. Plug the connecting cable back into the operating unit.
12. Use the screws to secure the operating unit/protection cap to the relay module/power supply unit.
13. Mount the caps on the screw holes.
14. Insert the plug of the relay module/power supply unit into the socket.