Lutz-Jesco EASYPURE 1000, Руководство по эксплуатации

Страница: 26 / 34

Maintenance
Finishing maintenance
26
© Lutz-Jesco GmbH 2015 BA-70200-02-V01
Polymer preparing and dosing station EASYPURE Powder and Liquid Operating instructions
10.1.4 Cleaning the container
Precondition for action:
ü
The system has been disconnected electrically and is protected
against reconnecting.
To minimise the danger of slipping and injury, the container should be
cleaned whenever necessary, as moisture absorption by specific dry
substances can increase the danger of slipping.
10.1.5 Cleaning the ultrasonic sensor
Precondition for action:
ü
The system has been disconnected electrically and is protected
against reconnecting.
Perform the following working steps:
1.
Open the screw connection under the sensor.
2.
Clean the underside of the signal generator (red) with a cloth.
10.2 Finishing maintenance
Perform the following working steps:
1.
Make a note of the date and scope of the maintenance performed.
2.
Attach a sticker displaying the maintenance date to the device.
3.
To restart the system, proceed in accordance with the instructions in
section 9 „Start-up“ on page 20.
ü
Maintenance completed.