Installation
Installing the device
13
© Lutz-Jesco GmbH 2017
Subject to technical changes.
170518
BA-20710-02-V05
Chlorine control valve
C 7700
Operating instructions
7 Installation
WARNING
Increased risk of accidents due to insufficient qualifica-
tion of personnel!
Chlorinators and their accessories must only be installed, operated
and maintained by personnel with sufficient qualifications. Insufficient
qualification will increase the risk of accidents.
ð
Ensure that all action is taken only by personnel with sufficient and
corresponding qualifications.
ð
Prevent access to the system for unauthorised persons.
NOTE
Damage to the system due to incorrect installation
The failure to observe installation instructions (e.g. use of unsuitable
tools, incorrect torque) can damage the system parts.
ð
Use suitable tools.
ð
Note the specified torque.
7.1 Installation location
The regulation valve is installed in the dosing device room. We do not
recommend installation in the same room as the chlorine gas supply.
The room must fulfil the following requirements:
n
secured against access by unauthorised persons,
n
protected against weather conditions,
n
frost-free,
n
permissible ambient temperature adhered to (see Section 5
"Technical data" on page 11),
n
room of sufficient size to allow trouble-free assembly as well as
inspection and maintenance of the device at all times,
n
an electrical connection is given,
n
the room can be ventilated well,
n
the room must comply with the locally valid prescriptions.
7.2 Installing the device
CAUTION
Danger of personal injury and material damage!
If the device is fixed with screws and no washers, it may fall and get
damaged.
ð
To fix it to the wall, use the large washers supplied in the scope of
delivery.
The device must be installed perpendicularly to a flat wall surface and
must be easily accessible for operation.
Precondition for action:
ü
A flat wall.
ü
The mounting material is suitable for the wall.
Resources required:
@
Water level
@
Drill
@
Fork wrench SW10
Perform the following working steps:
1.
Hold the device against the wall. The motor points to the right and the
hand knob points upwards.
2.
Mark the mounting point on the wall.
3.
Drill in the marked holes and insert the rawlplug.
4.
Secure the wall panel with the screws and washers included in the
scope of delivery.
ü
The device is fitted on the wall.
