![background image](http://html1.mh-extra.com/html/lutron-electronics/aurora-ar-ent-2s3d-series/aurora-ar-ent-2s3d-series_package-installation-manual_1951053008.webp)
1
2
3
4A
4B
Lutron
|
8
Need help? Contact Lutron Technical Support 24/7: 800.523.9466
lights controlled by one switch
Uninstall existing switch
(wires attached to screws only)
Remove wallplate
Unscrew existing switch
and pull it forward out
of the wall
To avoid fire, shock or
death,
turn power off
at corresponding circuit
breaker or remove fuse.
Turn power off at
corresponding circuit
breaker or remove fuse
1
✓
Helpful Hint:
Save your wallplate and screws.
Turn screw to loosen and
disconnect wires (1, 2, 3)
from the switch.
B.
Two insulated wires
inserted
into back of existing switch
.
One ground wire attached
to a screw.
To uninstall switch,
refer to step 4B.
A.
Two insulated wires
attached to a screw
. One
ground wire (green or bare)
attached to a screw.
To uninstall switch,
refer to step 4A.
Uninstall existing switch
(wires attached to back of existing switch)
Insert screwdriver (included in
package) into the holes found on
the back of existing switch and
pull out wires (1, 2). Loosen
screw and disconnect ground
wire (3).
OR
Once switch is pulled out, you should see one of the following:
3 (ground wire)
1
2
3 (ground wire)
Traditional
Designer
2
Neutral
Neutral
NOTE:
If intending to install an AuroRa
®
switch in this location, ensure
neutral is available before
disconnecting/uninstalling switch.
✓
Helpful Hint:
For wiring diagram for lights
controlled by one switch see
step 3A on page 21.
WARNING