![background image](http://html1.mh-extra.com/html/lutron-electronics/aurora-ar-ent-2s3d-series/aurora-ar-ent-2s3d-series_package-installation-manual_1951053013.webp)
4
5
6
7
8
Lutron
|
13
Need help? Contact Lutron Technical Support 24/7: 800.523.9466
1
2
3
Uninstall switch
A.
Tag the wire attached to
the different colored screw.
This screw is usually labeled
COMMON.
B.
Disconnect the wires from
the switch.
4 (ground wire)
Refer to page 8 step 4B for
instructions. (pull out wires 1, 2, 3)
2
1
3
4 (ground wire)
Neutral
NOTE:
If intending to install an AuroRa
®
switch in this location, ensure
neutral is available before
disconnecting/uninstalling switch.
Install dimmer or switch
brass screws
black
screw
Wire
Connector
brass screws
ground wire
green wire
Switch
Dimmer
neutral wire
ground wire
green wire
A.
Connect the green or bare wire
(ground wire) to the green wire on the
dimmer/switch with a wire connector.
B.
Connect the tagged wire to
the black colored screw on
the dimmer/switch.
C.
Connect one of the remaining
wires to either of the gold colored
screws (brass) on the dimmer/switch.
D.
Connect the remaining wire to the
remaining gold colored screw (brass)
on the dimmer/switch.
E.
For
AuroRa
switch connect the
neutral (usually white) wire to the
silver colored screw on the switch
using white wire provided by Lutron.
(see page 22 for additional info)
Figure 4B
Figure 4A
black
screw
neutral wire
silver screw white wire
(provided
by Lutron)
OR
Designer
Traditional
Turn power on at circuit
breaker or replace fuse
Mount dimmer or switch
Replace wallplate
✓
Helpful Hint:
See page
6—installing the designer insert
if using designer wallplate.
To avoid fire, shock or death,
if breaker trips
do not
reset
breaker to “on” again until
fault has been corrected.
WARNING