12
Chapter2
Monitor Assembly
Attention
For normal work of the monitor, before use please read this chapter and the Patient Safety
chapter and assemble in accordance with the requirements.
2.1
Open Package and Check
Carefully pick up the monitor and accessories from the package box, and properly keep the package
materials for future transport or storage. Please check the accessories with the package checklist.
Check whether there is any mechanical damage;
Check all the exposed cables and plug in some accessories for test.
Any problems should be immediately raised to the Sales Department of our Company or our agents.
2.2
Connect with AC Cable
Procedures to connect with AC power cables:
Make sure the AC supply complies with the following specification: 100-250VAC
，
50/60Hz
Use the power cables provided with the monitor together. Plug in the power cable into power supply
interface of the monitor, while insert the other end of this cable to a 3-phase earthing power socket.
Attention
Connect the power cable with the sockets special for hospital use.
If deemed necessary, connect with an equal-potential earthing cable. Refer to the equal-potential
earthing part in the Patient Safety chapter.
Attention
In case configured with a battery, the equipment after transport or storage must have the
battery taken for charging. Thus in case of direct booting without connection with AC power
supply, the equipment may not work properly due to insufficient power. With AC power supply
connected, the battery will be charged no matter the monitor is booted or not.