CORD AND PLUG INSTALLATION SAFETY INSTRUCTIONS
The length of the cord used on this appliance was selected to reduce the hazards of becoming tangled in or tripping over a
longer cord. If a longer cord is necessary, an approved extension cord may be used. The electrical rating of the extension cord
must be equal to or greater than the rating of the air purifier. Care must be taken to arrange the extension cord so that it will not
drape over the countertop or table-top where it can be pulled on by children or accidentally tripped over.
FEATURES - OPERATIONS
PRE-OPERATING INSTRUCTIONS
1. When removing the air purifier from the packing case, visually check for shipping damage. Please contact your dealer
immediately if the unit bears any sign of damage.
2. Keep shipping carton and packing for use in the unlikely event that your LURACO Technologies unit needs servicing. If
this unit is shipped without the original packaging, damage could occur and void the warranty.
3. Your LURACO Technologies air purifier comes to you ready for use, as the multi-stage filter cartridge has been installed
in the unit.
PLEASE FAMILIARIZE YOURSELF WITH THE INSTRUCTIONS THAT FOLLOW BEFORE CONNECTING THE UNIT
TO A POWER SOURCE.
OPERATING INSTRUCTIONS
1. Remove the Air Cleaner from its protective plastic bag.
2. Choose a suitable location, tabletop or shelf ensuring that both the air intake and exit are unobstructed. Remember, air
enters the front of the unit and exits from the rear.
3. Turn the Power Switch ON to operate the unit.
4. To operate the unit as a cleaned air fan, gently rotate the top part completely 180 degrees clockwise direction. FIG. 2
CLEANING INSTRUCTIONS
Turn off and unplug unit before cleaning. A soft damp cloth and non-abrasive cleaner may
be used to remove any excessive dirt
or fingerprints. Treated like any other quality appliances.
The pre-filter is washable. It can be cleaned with water or vacuum and reused after dried. Do not wash the multi-stage filter
cartridge. It should be disposed after used.
CHANGING THE FILTER
FIG. 1
Attention:
always unplug the unit when cleaning or
changing the filter.
The multi-stage filter cartridge should be replaced on a
regular basis. In most cases, we recommend a filter
cartridge replacement every THREE months.
To replace the filter, use the following steps.
1. Press the Release Button to remove the Front Face
2. Remove Pre-Filter
3. Gently pull up on the finger tab to remove the Main
Filter from the unit
4. Remove the replacement filter from its packaging and
install it to the unit. Note that: The gasket foam side
should face the fan.
5. Install the unit’s front face. Ensure that it’s securely
locked.