Lupus Electronics LUPUSEC-XT2, Руководство пользователя

Страница: 133 / 148

133
ENGLISH
In-wall relay without electric meter
1.
Test button

Keep the button pressed for 10 seconds to send the
learn signal to the control unit.

Pressing the button briefly activates or deactivates
the relay.
2.
LED indicator
a.
On: relay on
b.
Off: relay off
c.
Flashes twice: signal transmission
3.
Switch input
4.
Switch input (3 V reference)
5.
3 V output - direct current (DC)
6.
230 V AC input
Phase (brown - L)
7.
230 V AC input
Neutral conductor (blue - N)
8.
230 V AC output
Phase (brown - L)
9.
230 V AC output
Neutral conductor (blue - N)
Caution:
Only a certified electrician or electrically instructed person knowing and
understanding current and the inherent hazards is allowed to perform the installation.
Put the in-wall relay without electric meter into operation
1.
Interrupt the electrical power supply during the installation to prevent short circuits.
2.
Connect the 230 V supply line to the input (6 + 7) and the 230 V end device cable
to the output (8 + 9).
3.
To be able to actuate the relay externally, connect an additional switch to the
switch input (3 + 4). If the external switch requires a 3 V direct current connection,
connect it to the 3 V direct current output (5) of the in-wall relay.
4.
Open the control unit menu  Sensors  Add and click on Start.
5.
Keep the Test button (2) pressed for approx. 10 seconds. The relay transmits the
learn code and the LED flashes twice.
6.
As soon as the control unit received the learn code, the sensor list indicates the
sensor. Add the in-wall relay to the control unit with “Add”.