Lupus Electronics LUPUSEC-XT2, Руководство пользователя

Страница: 11 / 148

11
ENGLISH

To avoid the contact with splash or dripping water and aggressive liquids.

That the device is not operated close to water. In particular, never submerge the
device (do not place any objects filled with liquids, e.g. vases or drinks, on or next
to the device).

That no foreign objects enter the device.

That the device is not subject to great temperature fluctuations, as this may cause
humidity to condense and cause electric short circuits.

Not to expose the device to excessive vibrations.
Warning
When in doubt do not assemble, install, and wire the system by yourself,
but hire a specialized electrician. Improper and unprofessional execution
of works at the power supply system pose a danger to you and other
persons.
Install the control unit
You can either position the LUPUSEC-XT2 in a central place or mount it to the wall.
For the latter purpose, screws, dowels, and a drilling template are included in the
scope of delivery. To mount the device to wall, remove the rubber nubs from the
bottom of the device.
Connect the control unit
1.
Remove the rubber cover from the back and turn the battery switch to ON.
Note :
In case of power failure, the internal battery can supply the control unit with power for
approx. 12 hours.
2.
Connect the LAN cable to the control unit and then connect it to your router. Most
routers are equipped with several ports for gadgets.