Acuity LS
Page 7
Operating Manual #OMA20200327
Figure 4. Battery removal. The metal tube around the battery serves to provide electrical contact to
the negative side of the battery. NOTE: Older model shown, but battery replacement is the same.
System Restart
To perform a system restart of the Acuity LS device, remove the battery and wait 10 seconds, then install
the battery per the instructions above. Performing a system restart has no effect on the data; all data will
remain stored on the Acuity LS device.
NOTE: consult Luna if there are questions concerning the system
restart.
4 .
S
O F T W A R E A N D
D
R I V E R
I
N S T A L L A T I O N
This section provides instructions for installing the software and drivers needed to communicate with
Acuity LS. Please ensure that your computer meets these basic system requirements:
•
Laptop or desktop computer with Windows 7, 8, or 10 (64 bit)
•
500 MB available hard drive space
•
One (1) available USB port
Acuity LS User Interface Software and USB Driver Installation
NOTE: Do not plug the Acuity LS RS-485 communications cable into the computer until after the drivers
are installed on the computer, otherwise Windows may attempt to install incorrect drivers automatically.
1. Insert the CD or USB flash drive that was provided with the Acuity LS product shipment. If these
are not available, please contact Luna for copies of the software and drivers.
2. Use Windows file explorer to navigate to the media drive. (shortcut: Windows file explorer can be
accessed with
“Windows” + “E” keys)
