Lumio Crystal Touch Series, Руководство интегратора

Страница: 25 / 44

24
7.4 Connecting the LED PCB Wire to the PCB Controller
After connecting the sensors to the PCB Controller (see
Connecting the Sensors to the PCB Controller on page 20
),
connect the LED PCB wire to the PCB Controller with the LED PCB wire extension cable.
To connect the Touch Screen to the LED PCB Wire extension cable:
1. Unroll the LED PCB wire extension cable.
Figure 18 LED Wire Cables
Note
: Both ends of the LED Wires are connected to 2 pin male connectors.
2. Insert the 2 X Male LED wire connector into the Female connector located on the Active Barrier of the
Touch Screen.
Not
e:
• Ensure that the prongs of the 2 X Male connector fit correctly into the Female connector
•
Ensure that the 2 X Male connector locks tight into the Female connector
The following picture describes LED PCB wire connection to the LED PCB wire extension cable.
Figure 19 Active Barrier – LED Wire Connection