www.lumi-o.com
Installation
fig.1
Platform
Right and left ramp
fig.3
fig.5
fig.6
fig.4
C OMBO WEDDING C AKE I I
Follow steps 1, 2 and 3* of
The Wedding Cake II
instruction sheet.
fig.2
3-
Attach the platform to the
left and right ramps using the 2 “
bolts (4), washers (4) and
locknuts (4). (fig.3)
4-
Slide the rails of the ladder
onto the assembled portion of the
step. (fig.4)
5-
Lower the assembled
portion of the ladder until it rests
on the toprail. Fix the platform to
the toprail of the pool introducing
the straps into the opening of the
platform and under the toprail.
(fig.5)
2-
Install the two foam pads
in the upper back of the step .
(fig.2)
N.B move the step diagonally into
the water to allow the air to escape.
Place the step by the wall leaving
at least 1 Inch from the wall. Ensure
that the step touches the ground
solidly. Fill the ballast unit with sand**,
seal with the plastic cap and put the
ballast unit on top of the step as
illustrated on step 6 of the Wedding
Cake II instruction.
* D o not install the deck b r ac k et
f r om s t ep 3 .
** N ot include d
M a t e r ial included:
4x
16x
6x
13x
¾“ sc r e w
2“ B ol t
2x
S a f e t y c abl e
S t r ap s
F oam pad s
R ig h t and le f t r am p
B as e
P l a t f o r m
P i v oting ladde r
1x
Helpful hint : To ease the installation of the rails and bolts, use a screwdriver to line up holes.
L ong and
sho r t sup p o r t r ail s
Step 1
p
Step 2
p
Step 3
p
Step 5
p
Step 4
p
Step 6
p
2½“ B ol t
3½“ B ol t
Cap
Rev. 2007-11-26
1-
Put the step on the side to
fix the short support rail on the step.
Screw from the inside using the
predilled hole with the 2 ½ bolt(1),
and washer(1). (fig.1)
Washer
Locknut
6-
Stabilize the assembled
portion of the ladder to the steps
using the ¾” screws (8). (fig.6)
Put the cap on the short rail.
Read carefully the cautions and every steps before assembly and using your step.
Caution : File off all stripped or sharp edges before assembly to avoid injuries and pool damage.
p.1
