LX_FR601-INS-LAB-RevD21 6
UPHOLSTERED BACK ASSEMBLY, ALL MODELS
upholstered back
upholstered skirt
threaded knobs
upholstered back’s knockdown brackets
steel tube
mechanism’s bayonet links
bracket and link to be even
threaded knob through
large bayonet hole in link
knockdown bracket
bayonet link
1. Lift the skirt on the rear of the upholstered back. To make assembly easier, hold skirt up with
a small piece of tape to fully expose the knockdown brackets that are to be mated to the two
bayonet lugs on the recliner mechanism.
2. Remove two pre-installed threaded knobs from back (one on each side).
3. Carefully guide the upholstered back onto the mechanism, inserting both bayonet links at the
same time through the two cutouts located in the bottom of the back.
4. Push down firmly on the back until the recliner mechanism bayonet links are fully engaged in
the upholstered back knockdown brackets. The top of bayonet link should be even with top of
knockdown bracket, as shown above.
5. Once the back is properly seated on mechanism, insert the threaded knob through bayonet
link, knockdown bracket and steel tube (one on each side). Secure hand tight.
6. Remove tape and lower upholstery skirt. Secure back skirt with the skirt hook and loop strips.