background image

700175CR-INS-LAB-RevB14  

1

700175CR UPRISE ONYX FOLDING WALKER: 

ASSEMBLY & OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE

 WARNING: Important! Read and understand these instructions before assembling or using 

the UpRise Onyx Folding Walker. If you do not understand any part of these warnings or 

instructions, contact a healthcare professional for direction in the use of this product. If the 

UpRise Onyx Folding Walker is not properly assembled, personal injury and damage to the 

Walker could result.

 WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT use 

substitute parts. Use only Lumex replacement parts. The use of non-Lumex replacement parts 

could cause personal injury, property damage, and void the warranty.

 WARNING: This product has a maximum weight capacity of 400 lb, EVENLY DISTRIBUTED.
 WARNING: Always use caution when using this product on wet or slippery surfaces.
 WARNING: Notice for California Customers- California Proposition 65 WARNING: This product 

contains a chemical known to the State of California to cause cancer and reproductive or 

developmental harm.

 WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury caused 

by improper assembly or use of this product.

INTENDED USE

The Lumex 700175CR UpRise Onyx Folding Walker is intended as a dual-purpose mobility aid and rising aid. It is 

recommended for use by users whose height is between 5'4" and 6'2". Please consult a healthcare professional for 

proper adjustment, as recommended user heights are an approximation.

UNPACKING

Remove walker frame and leg attachments from carton and protective packaging. Check for obvious damage 

to the carton or its contents. If damage is evident, do not use the product; please notify the carrier and your 

Graham-Field authorized distributor for further instruction.

ASSEMBLY
Install Leg Attachments

1.  Depress the leg assembly button and insert the leg 

attachment into the leg until the leg assembly button pops 

out of its hole on the frame, as shown at right.

2.  Repeat for other three legs.

Adjust Walker Height

Handgrip-to-floor height is adjustable between 32" and 39". 

Each walker leg is equipped with several height adjustment 

positions, as shown at right.
1.  To adjust leg height, depress the height adjustment button 

and twist the leg attachment to the desired height until the 

height adjustment button pops out of the appropriate hole.

2.  Repeat for other three legs.

 WARNING: Before proceeding, ensure leg assembly 

buttons protrude fully from frame holes, height 

adjustment buttons protrude fully from height 

adjustment holes, and all legs are adjusted to the 

same height.

Open Walker (see picture at right)

1.  Grasp one handgrip and pull away from center of walker.
2.  Repeat with other handgrip.
3.  Push handgrips away from each other until the walker release mechanism clicks into place. 

Info: You will hear the release mechanism click into place.

4.  Walker is properly opened when release mechanism push button is up.

handgrip

secondary

handgrip

release

mechanism

push

button

height

adjustment holes

height

adjustment

button

walker tip

leg

attachment

rear

leg

leg assembly

button

frame

700175CR Lumex UpRise

Onyx Folding Walker

Отзывы: