6450R-2-INS-LAB-RevA11
1
6450R-2: TOILET SEAT RAIL, WIDTH-ADJUSTABLE
ASSEMBLY & OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
Note: The most current version of these instructions can be found online at
www.grahamfield.com
WARNING: Important! Read and understand these instructions before installing or us-
ing the Toilet Seat Rail. If you do not understand any part of these warnings, cautions or
instructions, contact a healthcare professional for direction in the use of this product. If
this product is not properly assembled and installed, personal injury and damage could
result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO
NOT use substitute parts. Use only Lumex replacement parts. Non-Lumex replacement
parts could cause personal injury and damage.
WARNING: This product has a weight limit of 250 lb.
WARNING: Users who have limited physical capabilities must be assisted or supervised
when using this product.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury
caused by improper assembly, installation or use of this product.
INTENDED USE
The Toilet Seat Rail is intended to provide support and stability during toileting.
INSTALLATION
Unpacking
Remove Toilet Seat Rail from carton and protective packaging. Check for obvious damage to the
carton or its contents. If damage is evident, do not use the product; please notify the carrier and
your Graham-Field authorized distributor for further instruction.
Installation (Refer to Illustration)
1. Remove existing toilet seat.
2. Place mounting bracket on flat surface of bowl
and align holes. Ensure that mounting bracket
tube is to the rear, closest to the tank.
3. Replace toilet seat, inserting bolts through
mounting bracket holes and into toilet seat
mounting holes. Replace original nuts and
tighten.
4. Depress push buttons and install arms in
mounting bracket as shown. Ensure the Toilet
Seat Rail sleeves rest securely on the toilet rim.
5. Adjust Toilet Seat Rail arm width by engag-
ing push buttons in desired holes in mounting
bracket tube. Adjust the arms to desired width
of either 17" (inner holes) or 19" (outer holes).
WARNING: Ensure that mounting bracket push buttons are locked in place before use.
Toilet Seat Rail,
Width-Adjustable
mounting
bracket tube
push button
mounting
bracket
mounting
bracket hole
arm
sleeve
