565G/565PG/565WG Ortho-Biotic Preferred Care
®
Recliners Operating Instructions
4
Upholstered
Back Cushion
Elastic Band
Shipping
Support
Clevis Pin
Wire Ring
Receiving Tubes
Frame
Key Ring
Strap
Hook
BACK ASSEMBLY
NOTE: Do not remove the shipping support which
is attached to the recliners upholstered back
until after the recliner's upholstered back
has been assembled to chair.
1. Obtain upholstered back assembly. Remove
the upholstered cushion from the metal back
frame (See fig. 1).
2. Remove pins and wire rings from frame
(See fig 1).
3. Slide back tubes onto receiving tubes on
frame and tap down until holes in back line up
with holes in frame (See fig. 1).
4. Replace pins and wire rings. Remove the
shipping support and discard (See fig 1).
5. Slide the lower elastic band on back to cover
pins. Position other straps evenly. The 2" elastic
bands can be adjusted for custom comfort.
6. At the bottom of the cushion you will find two
elastic straps with key rings on the ends (one
on each side). Replace back cushion over
metal frame. Attach each ring to the hook on
the frame next to the seat rings (See fig 2 & 3).
Figure 1
Figure 2
Figure 3
