2060R-INS-LAB-RevC15
1
2060R ROUND BATH STOOL:
ASSEMBLY AND OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
Info: The most current version of these instructions can be found online at
www.grahamfield.com
.
WARNING: Important! Read and understand these instructions before assembling or using
the Round Bath Stool. If you do not understand any part of these warnings, cautions or
instructions, contact a healthcare professional for direction in the use of this product. If the
Round Bath Stool is not properly assembled, personal injury and damage to the Round Bath
Stool could result.
WARNING: If components are damaged or missing, contact your GF authorized distributor
immediately. DO NOT use substitute parts. Use only Lumex replacement parts. The use of non-
Lumex replacement parts could cause personal injury, property damage, and void the warranty.
WARNING: This product's maximum weight capacity is 300 lb, EVENLY DISTRIBUTED.
DO NOT exceed the maximum weight capacity.
WARNING: Notice for California Customers- California Proposition 65 WARNING: This product
contains a chemical known to the State of California to cause cancer and reproductive or
developmental harm.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury
caused by improper assembly or use of this product.
INTENDED USE
The 2060R Round Bath Stool is intended as a bath
aid.
UNPACKING
Remove Bath Stool components from carton and
protective packaging. Check for obvious damage
to the carton or its contents. If damage is evident,
do not use the product; please notify the carrier
and your GF authorized distributor for further
instruction.
ASSEMBLY
1. Lay bath seat upside down with upper legs
pointing up on a flat, dry surface.
2. Attach lower leg by pushing in the locking
button and sliding the lower leg over the upper
leg until it clicks into place. Repeat for other
three legs. Ensure all legs are locked before
proceeding.
WARNING: Before proceeding, ensure all
locking buttons protrude fully from leg
attachment holes.
Height Adjustment
Depress adjustment button and slide lower leg
up or down until height adjustment button clicks
into place at desired height. Repeat for other three
legs. Ensure all legs are locked at the same height.
WARNING: Before use, ensure all adjustment
buttons protrude fully from height
adjustment holes, and all legs are adjusted
to the same height.
2060R Bath Stool components
seat
(with upper
legs attached)
legs
2060R Bath Stool assembled
locking
button
2060R Bath Stool height adjustment
lowest
highest
height adjustment button
