Lumenier Hydra Edition QAV210, Быстрый старт

Страница: 9 / 17

Quick Setup
Pre flight checks
Perform these steps at the beginning of every flight session.
1. Check your aircraft for signs of visible damage. I.e cracks in arms or carbon
fibre. Damaged electronics, cut or disconnected wires. Or bent, cracked or
chipped propellers. Replace or repair components that could possibly fail mid
flight.
2. Fully balance charge your drones LiPO battery at 1C. Please consult your
battery chargers user manual for charging LiPO batteries. Also ensure your
goggle battery and radio battery are also fully charged. Instructions on how to
charge the goggle and radio are also described in their respective user
manuals
3. Perform a ground test by placing the drone on a level surface with props
removed. Turn your radio and goggles on and check you are receiving full
radio signal and clear video transmission. Also check that your video signal is
not going to interfere with other pilots in the vicinity.
4. Connect a battery, arm the quad and test all controls are working as they
should and the drone responds to all inputs. The motors may slowly increase
in speed due to the drone trying to level itself. This is normal without props on.
Don’t apply too much throttle while performing these checks as you may risk
burning out motors or other electronics. The drone requires airflow to keep the
electronics cool.
5. Check the drones failsafe by applying a small amount of throttle and then
turning the radio off. After a second or two, the drone should disarm and the
motors should stop spinning. If the motors continue to run, the drones failsafe
is not set and you should not fly without resetting the failsafe to zero throttle.
FLYING WITHOUT FAILSAFE SETUP CAN CAUSE A FLYAWAY AND YOU
MAY LOSE YOUR DRONE OR CAUSE UNNECESSARY INJURY TO
PEOPLE OR DAMAGE TO PROPERTY.
8