Lumascape ZDClink Luxor SATlink, Руководство пользователя

Страница: 17 / 40

17
Operating the Controller
Only one luminaire can be addressed at a time.
Attempting to address more than one luminaire
at a time can result in assignment failures.
Assigning Luminaires into Groups
Figure 14: Luminaire assignment wire diagram
The lighting assignment screen is automatically displayed when
a Lumascape low-voltage LED luminaire or device containing
ZD Technology or ZDC Technology is connected into the
assignment ports of the facepack. This mode can also be forced
by navigating to
Setup and selecting Assign .
• Enter this mode by placing two separate wires from a single
Lumascape low-voltage LED luminaire or device containing
ZD Technology or ZDC Technology into each of the
assignment ports on the front of the facepack. The wires
must maintain contact inside the assignment ports during
the entire process.
• Navigate to Program and press the scroll wheel to initiate
assignment. When complete, the screen will show
“Assignment Successful” or “Assignment Failed.” If the
assignment fails, reposition wires and try again. If the
problem persists, the board or device may either be defective
or not programmable.
• The assigned group number is stored in the device and not
in the facepack. Thus, power loss or other errors within the
Luxor controller will not affect the luminaire assignment. If
a device (e.g., LED board, lamp, CUBE) is replaced, the new
device must be programmed to the desired group number.