12
Manual XC250
EN
Use the SmartGraph3 PC software to carry out a detailed analysis
and visualisation of your measured results. Only by employing
this PC software can all options of the measuring device for
visualization and functioning be utilized (e.g. data export into an
Excel/PDF file or data output in form of a printout).
Installation conditions
Ensure that the following minimum requirements for installing the
SmartGraph3 PC software are fulfilled:
• Supported operating systems (32 or 64 bit version):
– Windows XP from service pack 3
– Windows Vista
– Windows 7
– Windows 8
• Software requirements:
– Microsoft .NET Framework (is automatically installed
during the software installation, where applicable)
• Hardware requirements:
– Processor speed: min. 1.6 GHz
– USB connection
– 2 GB RAM, minimum
– 1 GB hard disk space, minimum
Installing the PC software
1. Download the current PC software from the Internet. To do
so, visit the website www.smartgraph3.de/download.
2. Double-click the downloaded file.
3. Follow the instructions of the installation wizard.
Starting the PC software
1. Start the SmartGraph3 software.
2. Switch on the device (see chapter Switch-on and
measurements) if necessary.
3. Connect the device to your PC via the USB connection cable
provided in the scope of delivery. After a few seconds (up to
one minute) the device is automatically detected and added
to the device list in the SmartGraph3 software.
Information about using the PC software is provided in the online
help.
The accurate functionality of the device was tested during
production a number of times. However, if functionality faults do
occur, then check the device according to the following list.
The device does not switch on:
• Check the loading status of the batteries. Change the
batteries when the message
Batt lo
is displayed upon
switch-on.
• Check that the batteries are properly positioned. Check the
polarity is correct.
• Never carry out an electrical check yourself; instead, contact
your Lufft
®
customer service.
PC software
Errors and faults