EN
Manual XC200
5
Switch-on and measurements
Note:
The cross control is very sensitive. Therefore, avoid dirt on the
control panel, because it could be misinterpreted by the device as
keystroke.
Before use make sure that the touchscreen control panel is
dirt-free.
If required clean the touchscreen control panel according to
chapter Cleaning the device on page 8.
1. Press the On/Off key (4) until a beep is emitted.
2. The device performs a short self-test.
– The device name and firmware version is shown on the
display.
– The battery charge is indicated on the display.
– The device is ready for operation.
– The displayed units are based on the settings of the last
utilization.
3. Select the desired measuring mode.
4. Point the device at the area to be measured.
– The measured values will be displayed.
Note:
Note that moving from a cold area to a warm area can lead to
condensation forming on the device's circuit board. This physical
and unavoidable effect can falsify the measurement. In this case,
the display shows either no measured values or they are
incorrect. Wait a few minutes until the device has become
adjusted to the changed conditions before carrying out a
measurement.
Key lock
1. Briefly press the On/Off key (4) during operation.
– The device emits a short beep.
– The following message appears on the display: LoC on.
– Key lock is activated.
2. Press the On/Off key (4) again.
– The device emits a short beep.
– The following message appears on the display: LoC off.
– Key lock is no longer activated.
Configuration mode
1. Press the Left/menu key (11) for approx. 2 seconds.
– The device emits a short beep.
– The CFG symbol (12) is displayed in the upper right corner.
2. Use the Right/back or Left/menu key to choose from the
available settings.
– Please note that some of the settings can only be selected
with a certain measuring mode.
Configuration
mode
Description
Lamp
Setting brightness.
Available are values between 20 and 100 %.
Switch-off after 30 min unless with setting AL.on.
Pabs[hPa]
Only available when the unit g/kg is active.
Specifying the absolute pressure (value range: 600 and
1200 hPa).
1. Enter the value using the cross control (2).
2. Confirm with the OK button (10).
Alt.[ft.]
Only available when the unit gr/lb is active.
Specifying the local altitude in feet
(value range: -999 and 9999 ft).
1. Enter the value using the cross control (2).
2. Confirm with the OK button (10).
CAL1
Specifying the temperature offset.
1. Enter the value using the cross control (2).
2. Confirm with the OK button (10).
CAL2
Only available, when % rH is active.
Specifying the offset for relative humidity
(value range: +/- 30 % RH).
A negative offset allows no measured values of less than
0.00.
1. Enter the value using the cross control (2).
2. Confirm with the OK button (10).
TH
HOLD
%WT
g/m
3
g/kg
Pabs[hPa]
SENS
MAT
TEMP
Alarm
Alt.[ft]
CAL12
gr/lb dp °C °F % rH
CM
m/s
ppm °F °C
IR
MAX
DP
MIN
AVG
CFG
ACT
18
12
