Ludlum Measurements 25009185, Руководство пользователя

Страница: 49 / 84

4.7. SETUP PAGE 2 43
• Tens Place (0-9)
• Hundreds Place (0-9)
• Number of Decimal Places (0, 1, or 2)
• Range (k on/off for cpm, cps, dpm, Bq;
µ
, m or none for R/h and Sv/h)
ð
If the Primary Units has changed to a value other than that used to previously
set this Alarm Point, the Alarm Point will be reset to 000.
Primary Units RATE/MAX Mode Alarm 2 - A short press of ON/ACK to select the value to
adjust, and MODE to adjust the value. Units will be the same as selected earlier with Primary
Units. The ALARM LCD Segment will remain solid to indicate Alarm 2. Set this Alarm to 000
to disable. Available values are:
• Ones Place (0-9)
• Tens Place (0-9)
• Hundreds Place (0-9)
• Number of Decimal Places (0, 1, or 2)
• Range (k on/off for cpm, cps, dpm, Bq;
µ
, m or none for R/h and Sv/h)
ð
If the Primary Units has changed to a value other than that used to previously
set this Alarm Point, the Alarm Point will be reset to 000.
Primary Count Units and Minimum Display -
A short press of ON/ACK to select the value
to adjust, and MODE to adjust the value. Available vallues are:
• Number of Decimal Places (0, 1, or 2)
• Minimum Units depend on the selected Primary Units. See list below.
Primary Units Primary Count Units Available
cps kcps cps c
cpm kcpm cpm c
Bq kBq Bq d
dpm kdpm dpm d
µ
R/h mR/h R/h
µ
R/h mR/h R/h
µ
R mR R
µ
Sv/h mSv/h Sv/h
µ
Sv/h mSv/h Sv/h
µ
Sv mSv Sv
Table 4.4: Primary Unit Multipliers
December 2021