The 8400-Series Voice Terminals Instructions for Installation, Switch,
Administration, and Programming the Options
555-015-725
Issue 1
October 1996
Programming the Options
Page 7-12
7
Viewing Information on Terminal Options and
Parameters
You can use the 8405D, 8405D~Plus, 8410D, 8411D, and 8434DX display screen
to view options and parameters that have been set at a particular voice terminal.
NOTE:
In order for you to view this information, the set must be on-hook and idle,
and it
must
be equipped with a display.
To view voice terminal options and parameters for a specific set:
1. While on-hook at that voice terminal, press
.
■
The light next to
goes on.
2. Press .
■
The light next to
goes off.
3. Enter ”00” OR “11” OR “##” according to the type of information you wish to
view.
— Press “00” to view what Speakerphone, Mute, Handset Expander,
Ringer Preference, and 1- or 2-line display options are set.
— Press “11” to view the Compander, Display Font (Domestic or
International), and DLI settings. Also shown is information about the
Primary and Adjunct levels selected (either ROM if the defaults are
operating or the checksum bytes of the parameter message that set
the levels).
— Press “##” to check the software version currently installed in the
terminal and whether the terminal is operating in
4-wire or 2-wire mode.
NOTE:
Be aware that the 8405 voice terminal uses the 8410 software,
and thus the display, in this case, will report that you are using
an 8410B or an 8410D rather than an 8405 set.
■
The information is displayed on the screen for approximately
five seconds and then disappears.
Shift
Shift
Mute
Shift
